I could be wrong, but I’m pretty sure that as of this morning, I’ve finished the electronics on the Integrated Sensors Electronic Bracer Mark III. (Wait haven’t I said that before?)
I’ve mounted the last electronic component. It seems to be working fine. All that remains to be done from this point, is finishing the software and the new leather bracer. And an enclosure.
The last part was the micro TV-B-Gone that I assembled a while back.
I’m pretty happy with how things have turned out, even if it has taken a few months to get to this point. It’s all self-contained and even though there are a couple wires, nothing is going to be flexing around – it’s one solid unit.
One minor challenge is the name – ISEB-6 is not entirely applicable as the Mark III has more than 6 sensors… and ISEB-8 just doesn’t roll off the tongue as well. #madscienceproblems
